Servo plug doesn't fit into receiver

[DtotheJ]

I am building a robot using a RoboteQ motor controller. It has tabs o
the RC plugs that prevent them from fitting into the RC receiver.
Receiver brand is JR XR3i.

Can I just cut the tabs off and plug them in

--
Dtothe
-----------------------------------------------------------------------
DtotheJ's Profile: http://www.rcgroups.com/forums/member.php?u=22157
View this thread: http://www.rcgroups.com/forums/showthread.php?t=90200

[triple7s]

I am building a robot using a RoboteQ motor controller. It has tabs on
the RC plugs that prevent them from fitting into the RC receiver.
Receiver brand is JR XR3i.
Can I just cut the tabs off and plug them in?
--
DtotheJ
------------------------------------------------------------------------
DtotheJ's Profile:http://www.rcgroups.com/forums/member.php?u=221575
View this thread:http://www.rcgroups.com/forums/showthread.php?t=902002

Yes.

[Chris Dugan]

I am building a robot using a RoboteQ motor controller. It has tabs on
the RC plugs that prevent them from fitting into the RC receiver.
Receiver brand is JR XR3i.
Can I just cut the tabs off and plug them in?
--
DtotheJ

------------------------------------------------------------------------

DtotheJ's Profile:http://www.rcgroups.com/forums/member.php?u=221575
View this thread:http://www.rcgroups.com/forums/showthread.php?t=902002

Yes.

In addition... be 100% certain that you are plugging them in the correct
way after that. Depending on the wiring of the plug and the lead you can
apply reverse voltage to the servo and fry it, that's what the tag is
there for... to prevent reverse connection. Usually it is only older
Sanwa or Airtronics gear that has this issue.

[n***@NOSPAMarrl.net]

On Thu, 31 Jul 2008 09:41:47 -0500, DtotheJ

I am building a robot using a RoboteQ motor controller. It has tabs on
the RC plugs that prevent them from fitting into the RC receiver.
Receiver brand is JR XR3i.
Can I just cut the tabs off and plug them in?

Thats what I did, just MAKE SURE you ALWAYS plug the plug in correctly
or you may burn up the servo.

WEB : http://www.n2dvm.com